![]() ![]() You can see we have have an impression in there. It's very flexible I'm going to pop out our object. Just going to go ahead gently pull on the sides. Now unfortunately I can't use this but we know not to make that mistake again. Just to show you what it would have looked like. So I'm going to go ahead and release this. That we have to be careful that it is in a complete up right position. we can't use this more but it does show that we need to be cautious when we do have an object that is taller than it is wide or really top heavy or bottom heavy. Here our rubber stamp mold took a tumble which is a good thing to be cognizant of and be aware of. A very interesting thing happened when we were away. It does only take twenty five minutes which is really hard to believe but it is true. Twenty five minutes have ellapsed and we're gonna go ahead and release our original objects from our molds which are now set up. These a million of these out there and you're probanbly wondering what to do with all of them. So now I'm just going to push him down like so. Now I wanna make sure that I have enough because in a moment I'm going to make sure that he is sitting on a flat surface so that when I do fill the mold, stay straight. Instead of like pressing it here and dragging it over and I'm actually going to take some from the sides and roll it over him. I'm to go ahead and put my ball of clay on top of him. Because I've want his features to be distorted at all. With this little skull button, I'm going to do a little different technique cause I want to shape it around the head. Now that that was a really easy because I could just depress it down into my form. That was really how quick and easy that was. So in the meantime I'm going to make another mold. Once that is ready and we will go ahead and pop out our button. Now we're going to wait twenty five minutes for that to cure. Go ahead depress a button or whatever you want. You just want to use a non porous surface. I have a plate here, from our kitchen which is a non porous surface. Go ahead and kneed it together or trying to remove are all these white striations. You just need to eye ball it and have approximately the same amounts of putty. You don't need them to be so exact with the mold putty. You need the measurement to be really exact. Unlike when you're doing resin and you have two part resin. What's nice is as long as these are not touching they'll stay pliable and fresh for very a long time. In the kit you're going to have part A which is a white substance and then part B which is purple. So what I'm going to do is first off I'm going to take off rings I have because I'm going to be kneading the mold putty in my hands. ![]() And that is Easy Molds two part Silicon Mold Putty. Thank you for joining us here at As we do another instructional video and today we're going to cover a very fun medium. Note: This audio transcript is auto-generated and may not be completely accurate. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |